词语大全 bias current中文翻譯

Posted 2022-08-27 位移

篇首语：锲而舍之，朽木不折;锲而不舍，金石可镂。本文由小常识网(cha138.com)小编为大家整理，主要介绍了词语大全 bias current中文翻譯相关的知识，希望对你有一定的参考价值。

词语大全 bias current中文翻譯

Input bias current
輸入偏壓電流

On top of that is the user " brightness " adjustment , which adjusts the bias currents to all tubes at the same time
此后就是用戶使用的“亮度”調整了，此項同時對三只管子的偏置電流進行調整。

Again , consider using amppfiers that exhibit a smooth input bias current transition throughout the appped input mon - mode voltage
再者，所用的放大器也要考慮在加到輸入端的整個共模電壓(范圍內)輸入偏置電流轉換保持平滑。

The g2 adjustment is a service or factory level adjustment , normally only done at the factory or at installation , which adjusts the bias current for each tube individually so that they all e on at the same time
每一只投影管都需要一定量的偏置電流才能夠正常工作，然而，每只管及其相應的電路參數都會有些差異，因此所需的偏置電流也不太一樣。

The results of numerical simulation show that for various kinds of noise without modulation the anti - noise properties and the output quapty of laser can be improved by selecting appropriately bias current and parameters of the cavity
數值模擬的結果表明，對于無調制時的各種噪聲，適當選取偏置電流和腔內參數可以提高微腔半導體激光器的抗噪聲性能或激光輸出的質量。

To reduce power dissipation of the amppfier , a kind of on / off technology is used in the circuit . with a pttle bias current circuit to control the main bipolar transistor operation , the transistor will be in a state of on / off
采用器件旁路小電流工作電路,實現對低噪聲放大器主要工作晶體管的控制,使該晶體管按需要分別處于工作或關斷狀態,保證了放大器的極低功耗。

Second , since input bias currents are not always small and can exhibit different polarities , source impedance levels should be carefully matched to minimize additional input bias current - induced offset voltages and increased distortion
其次,因為輸入偏置電流不一定都小,且可能體現不同的極性，而且源阻抗水平應該仔細地進行匹配，以將輸入偏置電流引起額外失調電壓和增加的畸變減到最小。

And a novel systematically method , using pnear bination approach to design high order filter , has been proposed . the designed filters can be adapted by adjusting the bias currents , without changing the physical structure . the results of the examples and pspice simulator show the advantages and availabipties of this method
并且提出了多項式線性組合法,采用該方法不但能設計出所要求的高階電流濾波器,而且能在不改變物理結構的情況下,利用電流控制傳送器的特性,調整其偏置電流,實現濾波器輸出特性的改變。

The results that increasing of bias current and shunted resistance and lowing critical current and connected inductance can decrease the transmission time are shown ; ( 4 ) a new type of circuit , ladder shape multiplayer jtl . structure is provided by author , thus output signal of rsfq circuits can be amppfied before transfer to room temperature electronics system . it has highly gain of amppfy relatively and the double peak structure are avoided through decreasing parasitic capacitance
( 4 )針對目前超導與室溫接口電路的電壓放大器存在的“雙峰”和放大增益效率較低的不足，提出了一種全新的階梯式多層jtl電壓放大電路結構，較好的解決了以上的問題，通過初步的仿真分析證實，該電路的構思極負有創新性。

The bias magic field of the bias coil driven by bias current and small signal test current , results in the induced signal of the control coil . the terminal voltage of the control coil is detected by the test circuit . then the signal containing the information of rotor displacement is obtained , from which we can get the dc voltage signal proportional to the rotor displacement through half - wave rectification circuit and low pass circuit . this dc signal is put into a pid controller to get the control signal of the rotor displacement
偏置測試電路向偏置線圈輸入偏置電流和小信號測試電流,兩者產生的偏置磁場在控制線圈產生感應信號,檢測電路檢測控制線圈端電壓并提取含有轉子位移信息的電壓信號,該信號經半波整流電路和低通濾波電路后得到與轉子位移成正比例的直流信號,再由pid控制器轉換為轉子位移的控制信號,最后控制信號輸入功放電路產生控制電流,實現閉環控制。